• Call Us: 0086-21-58386258
  • No.416 Jianye Road, shanghai, View on Map

Culture, charm and heritage

We offer a luxurious base from which to explore the city.

Raymond Mill Installation And Commissioning

Raymond Mill Installation And Commissioning

After we purchase the machine, we will personally arrange the person to install and debug. Let me talk about the preparations before the installation of Raymond mill and the debugging of Raymond mill and the precautions for use. 1. When the Raymond mill operation site has not been installed, it should be kept safely. The exposed surface should be coated with anti-rust grease and avoid Sun and rain, in order to prevent the body from rusting into the water, to establish a maintenance system. 2, the plant and foundation should be based on the Raymond mill installation base map size should have sufficient height and installation position, Raymond mill foundation should use high standard cement and must be buried with steel can be poured foundation, and buried pipeline or cable trench . After the cement foundation is poured, there must be a 15-day maintenance period. 3, should be equipped with 2 ~ 3 tons of lifting tools for Raymond mill installation and maintenance. 4. The Raymond mill shall be cleaned and inspected from the factory to the use time for more than 6 months. The main shaft system, transmission, grinding roller and analytical oil pool shall be cleaned and checked. After the cleaning inspection, sufficient lubricating oil shall be added to each component.

Raymond mill debugging (empty running test machine) 1, empty load running test machine, before the no-load test machine, the grinding roller device should be hung with the wire rope to avoid contact between the grinding roller and the grinding ring, then the host is empty Run the test machine for not less than 1 hour; the main engine should be stable when it is running, the oil temperature in the tank should not exceed 80 °C, and the temperature rise should not exceed 40 °C. The rotation direction of the main machine and the analysis machine is shown in Fig. 4. 2. The blower should be turned on at no load, and then loaded after normal operation, and then observe that it runs smoothly, no abnormal noise and vibration, the maximum temperature of the rolling bearing should not exceed 70 °C, and the temperature rise must not exceed 35. °C. 3. The test time of the load operation is not less than 8 hours. After the Raymond mill works normally, there is no abnormal noise in the whole machine. There is no air leakage at the joints of the pipes. After the test machine, the fastening bodies are tightened again and put into normal use.

Precautions for use: 1. In order to make the Raymond mill powder machine normal, the equipment “safe operation system for equipment maintenance” should be established to ensure the long-term safe operation of the Raymond mill, and necessary maintenance tools and grease. Corresponding accessories. 2. When the grinding roller device of Raymond mill is used for more than 500 hours to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time. The fueling tool can be used with manual fuel pump and grease gun. . 3. During the use of Raymond mill, there should be fixed personnel responsible for the care, the operator must have a certain level of technology. The Raymond mill must perform the necessary technical training before the installation to understand the principle performance of the Raymond mill and familiar with the operating procedures. 4. After using the Raymond mill for a period of time, it should be repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device should be carefully checked before and after the use. There is looseness and the grease is added.